 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| C8051F041 ANALOG PERIPHERALS 12-bit ADC 1LSB INL; Guaranteed Monotonic Programmable Throughput up to 100ksps 12 External Inputs; Programmable as Single-Ended or Differential Programmable Amplifier Gain: 16, 8, 4, 2, 1, 0.5 Data Dependent Windowed Interrupt Generator Built-in Temperature Sensor ( 3C) High-Voltage Differential Amplifier 60V Common Mode Input Range Offset Adjust from -60V to +60V 16 Gain Settings from 0.05 to 16 8-bit ADC Programmable Throughput up to 500ksps 8 External Inputs; Programmable as Single-Ended or Differential Programmable Amplifier Gain: 4, 2, 1, 0.5 Two 12-bit DACs Three Comparators Internal Voltage Reference Precision VDD Monitor/Brown-out Detector CAN2.0B 64KB ISP FLASH MCU PRELIMINARY HIGH SPEED 8051 C CORE - Pipe-lined Instruction Architecture; Executes 70% of Instructions in 1 or 2 System Clocks Up to 25MIPS Throughput with 25MHz System Clock Expanded Interrupt Handler 4352 Bytes Internal Data RAM (256 + 4k) 64k Bytes In-System Programmable FLASH Program Memory External 64k Byte Data Memory Interface 32 Message Objects "Mailbox" implementation only interrupts CPU when needed 32 Port I/O; All are 5V tolerant Hardware SMBusTM (I2CTM Compatible), SPITM, and Two UART Serial Ports Available Concurrently Programmable 16-bit Counter Array with 6 Capture/Compare Modules Five General Purpose 16-bit Counter/Timers Dedicated Watch-Dog Timer; Bi-directional Reset Internal Programmable 2% Oscillator: Up to 25MHz External Oscillator: Crystal, RC, C, or Clock Real-Time Clock Mode using Timer 3 or PCA Typical Operating Current: 10mA @ 25MHz Multiple Power Saving Sleep and Shutdown Modes MEMORY CAN Bus 2.0B DIGITAL PERIPHERALS ON-CHIP JTAG DEBUG & BOUNDRY SCAN VDD VDD VDD DGND DGND DGND AV+ AV+ AGND AGND TCK TMS TDI TDO /RST On-Chip Debug Circuitry Facilitates Full Speed, Non-Intrusive InSystem Debug (No Emulator Required!) Provides Breakpoints, Single Stepping, Watchpoints, Stack Monitor, Program Trace Memory Inspect/Modify Memory and Registers Superior Performance to Emulation Systems Using ICE-Chips, Target Pods, and Sockets IEEE1149.1 Compliant Boundary Scan Digital Power CLOCK SOURCES SUPPLY VOLTAGE ......................... 2.7V to 3.6V 64-Pin TQFP; Temp Range -40C to +85C UART0 UART1 P0 Drv P0.0 P0.7 Analog Power JTAG Logic Boundary Scan Debug HW Reset 8 0 5 1 C o r e SFR Bus SMBus SPI Bus PCA Timers 0,1,2,3,4 64K byte FLASH 32x136 CANRAM 256 byte RAM 4K byte XRAM MONEN VDD Monitor External Oscillator Circuit VREF DAC1 (12-Bit) DAC0 (12-Bit) Port 0,1,2,3 &4 Latches C R O S S B A R P1 Drv P1.0/AIN1.0 P1.7/AIN1.7 P2 Drv P2.0/CPx P2.7/CPx P3 Drv P3.0/AIN0.6 P3.7/AIN0.7 CTX0 CRX0 WDT XTAL1 XTAL2 VREF CAN 2.0B ADC 500KS/s (8-Bit) VREFA Prog Gain System Clock A M U X 8:1 DAC1 Internal 2% Oscillator CP0 + + + - P2.0 P2.1 P2.2 P2.3 P2.4 P2.5 CP1 CP2 DAC0 VREFA AIN0.0 AIN0.1 AIN0.2 AIN0.3 A M U X Prog Gain ADC 100ksps (12-Bit) Port 4 External Data Memory Bus Bus Control Address [15:0] P4 DRV Ctrl Latch P5 Latch Addr [7:0] P6 Latch Addr [15:8] P7 Latch P5 DRV P6 DRV P7 DRV TEMP SENSOR A M U X HVAIN+ HVAMP 8:2 Data [7:0] Data Latch HVAINHVREF HVCAP 8.6.2002 C8051F041 CAN2.0B 64KB ISP FLASH MCU PRELIMINARY SELECTED ELECTRICAL SPECIFICATIONS TA = -40C to +85C, VDD = 2.7V unless otherwise specified. PARAMETER CONDITIONS MIN TYP MAX UNITS GLOBAL CHARACTERISTICS Supply Voltage 2.7 3.6 V Supply Current (CPU Clock=25MHz 10 mA active) Clock=1MHz 0.5 mA Clock=32kHz; VDD Monitor Enabled 20 A Supply Current Oscillator not running; VDD Monitor 0.1 A (shutdown) Disabled Clock Frequency Range DC 25 MHz A/D CONVERTER Resolution 12 bits Integral Nonlinearity LSB 1 Differential Nonlinearity Guaranteed Monotonic LSB 1 Signal-to-Noise Plus 66 69 dB Distortion Throughput Rate 100 ksps Input Voltage Range 0 VREF V D/A CONVERTERS Resolution 12 LSB Differential Nonlinearity LSB 1 Output Settling Time 10 s COMPARATORS Supply Current (each Comparator) 1.5 A Response Time | CP+ - CP- | = 100mV 4 s PACKAGE INFORMATION D D1 C8051F040DK DEVELOPMENT KIT MIN NOM MAX (mm) (mm) (mm) A 1.20 0.15 1.05 A1 0.05 E1 E A2 0.95 b 0.17 0.22 0.27 12.00 10.00 0.50 12.00 10.00 - 64 PIN 1 DESIGNATOR 1 A2 e A b A1 D D1 e E E1 SPI is a trademark of Motorola, Inc.; SMBus is a trademark of Intel Corp.; I2C is a trademark of Philips Semiconductors |
Price & Availability of C8051F041
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |